Skip to main content

Live stream a meeting from OBS or a hardware encoder

Connect OBS or a hardware encoder to a live meeting with the Server URL and Stream Key, then go live, pause, and end the stream.

Written by Max Sherman

Who can do this: Administrators and Meeting Managers. Once a stream is set up, only the person who started it can use its controls.

ClerkDirect can receive video from streaming software such as OBS Studio, or from a hardware encoder, and show it to the public on your portal's live page. You run the stream from the Live Stream tab of the live meeting.

Important: the stream key changes every meeting

ClerkDirect creates a new Stream Key each time it prepares a stream, so each meeting has its own key. Copy the key into your encoder for every meeting. An old key won't connect.

Prepare the stream

  1. Start the live meeting. ClerkDirect prepares a stream for it automatically, without going live. See Run a live meeting from start to finish.

  2. On the right of the live meeting, select Live Stream.

  3. Make sure Input is set to RTMP encoder.

  4. The video area shows Server URL and Stream Key. Use the copy buttons, and the eye button to show the key.

Set up your encoder

In OBS Studio:

  1. Go to Settings > Stream.

  2. Set Service to Custom.

  3. Paste the Server URL into Server and the Stream Key into Stream Key.

  4. Select Start Streaming.

For a hardware encoder, enter the same Server URL and Stream Key in its custom RTMP destination settings. The Server URL starts with rtmps://, so your encoder must support RTMPS (RTMP over TLS).

When ClerkDirect receives your video, the player in the Live Stream tab starts playing and is labeled Preview. Until then it shows "ClerkDirect is waiting for input".

Go live

  1. Check that you're in a public session.

  2. Check the preview and the Broadcast audio meter.

  3. Select Go live. The player label changes to Live.

If you're recording with the room microphone, ClerkDirect asks Switch recording to live stream?. Select Stop recorder and go live. This stops the room recorder and switches audio and live transcription to the stream. Transcript text already captured is kept.

During the stream

  • Pause live stream and Resume live stream: pause the public stream, for example during a break.

  • Mute broadcast audio and Unmute broadcast audio: silence the stream's audio. The meter shows the audio level.

  • Open Public Stream: open your portal's live page in a new tab. This needs your public portal to be enabled.

  • End live stream: stop the stream. The live meeting stays open. To stream again, select Prepare another stream and enter the new Stream Key in your encoder.

To send the same stream to YouTube, Facebook, or another service, see Send your stream to YouTube, Facebook, or another platform.

When you end the live meeting, ClerkDirect ends the stream too. Stop streaming in your encoder afterwards.

Private sessions

You can only go live or resume the stream in a public session. If you switch to a private session while streaming, ClerkDirect asks you to stop the stream first. See Switch between public and private sessions.

Related articles

Did this answer your question?